• Active Topics  Back Forward Stop Play

Whirlwind Propeller blades

I really like this quote from wiki.. "The resulting design, the Yakovlev Yak-55, was a single-engined all-metal cantilever monoplane. The aircraft's wing is mounted midway up the fuselage and is of thick, symmetrical section to aid inverted flight"
MPF Competitor
Posts: 38
Joined: Mon Sep 26, 2016 5:37 pm

Re: Whirlwind Propeller blades

Post by SHIPCHIEF » Sun Nov 26, 2017 12:31 am

The plywood pitch fixture fits over the front of the downward sweeping blade. You slide it in from the tip until it snugs over the leading and trailing edges. It will need to be set vertical. It will rock and needs to be stabilized. Holding it in place with the digital level is quite a hand full.
I used this little furniture clamp to hold the digital level to the fixture. The clamp was placed so the back jaw rested on the propeller blade like a 3 leg stool, so the digital level's base was parallel to the propeller blade.
Then I used a carpenter's level to make sure the fixture was vertical.
Also the blade must be horizontal, and this needs to be done several times. I stood a ladder next to the blade tip and marked a reference point.
IMG_20171125_120204.jpg (1.59 MiB) Viewed 247 times

Post Reply Previous topicNext topic